How do I unlock my Lux tx500e thermostat?

Table of Contents

Press the small round inset RESET button behind the door of your unit using a small Philips screw driver. Reconfigure and reprogram as necessary. Thermostat is locked or cant adjust display Press the NEXT button three times then press the HOLD button once, this key sequence locks and unlocks your thermostat.

How do you unlock a Lux?

How to Unlock a Lux 1500 Thermostat

Press and release the “Next” button, in the center of the thermostat’s programming panel, three times.
Press the “Hold” button, and then release it.
Press and release the “Next” button three times, and then press and release the “Hold” button to lock the thermostat again.

How do I unlock my Lux Pro thermostat?

To do that, follow these instructions:

Bring the Set Slide switch to the RUN position.
Behind the thermostat’s circuit board, you’ll find the HW RST button. This is used to perform a hard reset.
Press and hold it for 3 seconds. This should unlock your thermostat.

How do you unlock a Lux tx100e thermostat?

TO UNLOCK THE KEYPAD: Press the UP/DOWN buttons to change each flashing digit, using the NEXT button to cycle through which digit is flashing. Press and hold the NEXT button for at least 5 seconds. The thermostat will return to the Normal Run screen without the padlock, and the thermostat is now unlocked.

How do I reset my Lux tx500e thermostat?

Take the front of the thermostat off the wall and look for a small round black reset buttons labeled “HW RST”. Hold this button down for at least 5 seconds and then let go. Again the screen should fully populate temporarily.

How do you unlock Lux in geo thermostat?

Press the dial towards the Blue Arrow two times. On the second press, hold it down for ten seconds and a small lock will appear on the thermostat indicating that the thermostat is now locked. To unlock the thermostat, repeat the process above.

How do you unlock Lux tx700u?

TO UNLOCK THE THERMOSTAT: Ensure the rotary dial is in the RUN position. A single press of any key will cause the words “ENTER CODE” to appear on the screen, along with “0000”. Enter the correct code, using the UP/DOWN keys, and the NEXT key. Press the NEXT key for at least 5 seconds.

How do you unlock a Lux 1500 thermostat?

Where is the reset button on my Lux thermostat?

Take the front of the thermostat off the wall and look for a small white round reset button on the right side labeled “H.W. Reset”. Hold this button down for at least 5 seconds.

How do I unlock an old Lux thermostat?

Can a Lux thermostat be used with a 3-wire zone valve?

© 2006 LUX PRODUCTS CORPORATION. ALL RIGHTS RESERVED Thank you for your confidence in our product. To obtain the best results from your purchase. systems. It cannot be used with 3-wire zone valves, 120 volt heating systems, or multi-stage heat pumps. Ask your dealer for other LUX thermostats to control those systems.

Can I use Lux Products with a 3 wire valve?