How deep should nut slots be?
The slots should be only deep enough so 1/3 of the string is above the top of the nut and 2/3 in the nut.
How high should the nut be on an acoustic guitar?
The top of the nut is shaped to follow the radius of the fretboard, and the string slots also follow this curve. To allow the strings to clear the top of the first fret, the bottoms of the slots should be . 030″ higher than the fret height.
How high should the nut be on a guitar?
Measuring the nut slot heights As a starting point, shoot for . 02” in between the top of the first fret and the bottom of the string at the first fret on the wound strings (low E, A and D), and . 018” for the plain strings (high G, B, and E). On acoustic guitars with a wound G, you will also shoot for .
How high should strings be at the nut?
A good measurement is about 1/16″ in from each end of the first fret (measuring from the top of the beveled fret ends). Put the two outside E strings on the guitar and, looking straight down on the top of the nut, move these strings together or apart until their spacing is correct for you.
How do I know if my nut slot is too low?
To check nut-slot height, hold the string down at the third fret, and see how much it moves over the first fret. This is similar to checking neck relief, but the string should move much less. If the string doesn’t move at all, chances are the slot is too low.
How do I know if my nut is too high?
If the nut is too low, the string will bump into the first fret when it is played and it will “buzz,” even if the rest of the instrument is properly set up and working well. If the nut is too high, playing at the first fret will be seriously impaired.
What happens when the guitar nut is too high?
Nut slots that are too high create a situation where the guitar is difficult to play in first position. They can also throw off the tuning and intonation. Nut slots that are too low will create what many players refer to as a “sitar” effect.
How do you get low action without fret buzz?
4 Tips To Getting Low Action Without Fret Buzz
- Use higher gauge string. Higher gauge strings are thicker and have more tension – which means they are going to vibrate as much when you pluck.
- Adjust neck relief.
How do you know if your nut is too high?
What is a screw slotting saw used for?
These general purpose saws are good for cutoff, slitting, and slotting applications in a wide range of material, including aluminum, iron, plastic, and steel. Use with an arbor (sold separately). Saws with a 2 3/4″ mill dia. are also known as screw slotting saws.
What size saw do I need for screw slotting?
Saws with a 2 3/4″ mill dia. are also known as screw slotting saws. Saws with 1 1/4″-2 1/2″ and 3″-8″ mill dia. are also known as plain metal slitting saws.
What is the best way to slot a nut?
The nut is best slotted if held in a vise. These are a very useful low-cost alternative to the extremely pricey nut slot files that are typically offered. And they will last you a long time.
How to tell if a nut slot fits the string?
Right: the slot really fits the diameter of the string, the nut material does not go above the halfway point of that diameter, and leaves the string a trace of clearance above the fret or the unfretted board surface. How much is a trace? I’m reluctant to assign a measurement—it’s very little. You can still see a bit of light.