How do you reset a bark collar?

Turn the battery to the OFF position using a coin. Wait 10 seconds. Turn the battery to the ON position. The collar light will turn solid green, then solid orange for two seconds.

Why is my bark collar not working?

Ensure that the battery is properly installed. Replace the battery. If the Bark Control Collar still does not beep, contact the Customer Care Center at 1-800-732-2677.

Why is my petsafe bark collar blinking red?

Collar features When the collar is not being used, turn off to conserve battery life. Flashes green or red to show battery status. Fits neck sizes up to 23 inches.

Why is my petsafe collar beeping but not shocking?

Touch both points on the collar while it is ticking or beeping. If you do not feel a shock, then there may be a problem with the receiver collar. Make sure you touch both points on the receiver at the same time when you hear the collar beeping. It will tell you definitively that the fence is or is not working.

How long does it take for a bark collar to work?

This must be done for at least a few days. The dog then considers the new anti bark collar of no importance, and then after 5 to 7 days of occasional wearing of the anti bark collar should it be switched on.

How do I know if the bark collar is working?

How to test your Bark Collar

  1. Press and release the power button to power the collar on.
  2. Watch for the green light to blink twice, then hold the power button. Continue to hold the power button through the red light.
  3. Release the button when the light turns blue to set the collar into test mode.

How do I know if my shock collar is working?

How do I know if my petsafe collar is working?

All you have to do is hold the tool against the contact points on your dog or cat’s receiver collar to check if the collar is working properly. The test light tool will light up if static correction is being activated. This accessory comes in most kits including a fence receiver collar, remote trainer, or bark collar.

How do I know if my petsafe collar is on?

Test the Receiver Collar with the Test Light walking toward • the Boundary Wire. If the Test Light flashes, check the fit of the Receiver Collar. Trim your pet’s fur where the Contact Points touch the • neck and/or purchase longer Contact Points by contacting the Customer Care Center at 1-800-732-2677.