How do I know if my Sea-Doo ring is worn?
If your jet ski’s wear ring is worn, you can expect one or more of the following symptoms:
- Cavitation in the pump.
- Decreased top speed and acceleration.
- The jet ski bogs down.
- You can see grooves or other signs of wear and tear on the surface of the ring.
When should I replace my Sea-Doo ring?
Take a close look at the wear ring, which is wrapped around your PWC’s impeller. The surface of the wear ring should be smooth, with minimal scratches. If you notice a significant gap between the impeller and the wear ring, it’s time to replace your wear ring.
What years did Sea-Doo make the SPX?
1995 Yamaha Waveraider 700 Specs Produced by Bombardier Recreational Products of Canada, the first Sea-Doo personal watercraft — or PWC — appeared in 1968. In 1995, the company released the Sea-Doo SPX, an updated version of the 1994 model.
What does a wear ring do?
Wear rings can be defined as a device used to seal the pressure leakage of the liquid between the inlet of the impeller and the pump casing. Wear rings are typically found on sewage pumps with closed impellers.
Where is the wear ring on a Sea-Doo?
A wear ring is quite simple, it’s a thick piece of plastic that wraps around the impeller. The gap between the impeller and the wear ring is very tight because it needs to be in order to push the water out. It’s best to think of a Jet Pump on a jet ski as a jet engine on a plane.
How fast does a 1995 Sea-Doo SPX go?
Finally, with this power source the 1995 Sea-Doo XP could reach a top speed of 50 mph under ideal conditions.
What does a pump wear ring do?
The wear rings in a pump serve three key purposes: Create the contact area between rotating and stationary parts inside the pump. Reduce internal recirculation from pump discharge to pump suction or between stages. Create hydraulic forces which stabilize the pump rotor.
Is the Sea-Doo wear ring SP GT XP GTS explorer genuine?
Brand new, genuine Sea-Doo Wear Ring SP GT XP GTS GTX Explorer. This is a factory original equipment part, not aftermarket. Non-current. Video Player is loading. This is a modal window. C & E HOLDING COMPANY. There was a problem filtering reviews right now. Please try again later. Fit perfectly on a 1998 GTS.
What happened to the wear ring on my seadoo?
This Seadoo had the original wear ring, and was suffering from terrible performance – the engine revved, but the ski barely moved. Upon close examination, the old wear ring’s interior surface was completely gone, leaving about a 1/4 inch gap all around the impeller.
Will this seadoo fit on a 1998 GTS?
Please try again later. Fit perfectly on a 1998 GTS. This Seadoo had the original wear ring, and was suffering from terrible performance – the engine revved, but the ski barely moved. Upon close examination, the old wear ring’s interior surface was completely gone, leaving about a 1/4 inch gap all around the impeller.