Can MacBook Pro battery be removed?
Carefully disconnect the battery from the logic board to avoid short-circuiting the board. Grab the plastic tab attached to the battery and pull it towards the front of the laptop. Remove the three (3) 6.5 mm tri wing screws securing the battery to the upper case using the Y1 screwdriver.
Can I remove MacBook Pro keyboard?
To remove the “normal” keys, use a thin, flat tool such as a pair of tweezers or a small screwdriver to get under the key at the bottom-left corner and push the prong out of its hole. Once it’s out, pull the key down from the top-right corner and wiggle until the left hand side of the key is detached.
Is my MacBook Pro a unibody?
The MacBook Pro features a case comprised of only two body parts: the upper screen half and the bottom body half. They do not use metal or plastic supporting frames like previous designs. Since the introduction of the unibody MacBook, similar laptop models have emerged from PC manufacturers.
How to remove the power button from MacBook Pro Keyboard?
STEP 1. In MacBook Pro the power button permanently attached to the keyboard via a ribbon cable. Before you can remove the keyboard you will have to release the power button. Remove two screws securing the power button. STEP 2. Lift up the power button and separate the ribbon cable from the case.
How do I replace the battery on a MacBook unibody?
Replacing the battery on a MacBook Unibody is an easy task. No tools specified. With the case closed, place the Unibody top-side down on a flat surface. Depress the grooved side of the access door release latch enough to grab the free end. Lift the release latch until it is vertical.
How to replace the keyboard on a MacBook Pro?
In a MacBook Pro the keyboard is mounted to the bottom side of the top case assembly. It means in order to replace the keyboard you will have to remove most internal components. You will need a set of fine Phillips and Torx screwdrivers. You will have to remove the logic board and cooling fans. You will have to remove the optical drive.
How do I remove the battery from the upper case?
Remove three 3.1 mm Phillips screws securing the battery near the edge of the upper case. When reinstalling the battery, be sure to install these three screws before proceeding to fasten the Tri-point screws. Use the battery’s plastic pull tab to lift and remove the battery from the upper case.