How do I reset my genie lift?

hold the button and turn the key switch to the ON position. hold the button and turn the key switch to the ON position. (O TO 10 SECONDS, 2 IS THE DEFAULT.

What does OL mean on a scissor lift?

When an overload event occurs, the Genie Smart Link platform controller will indicate -OL-, an alarm will sound and machine motion will stop. In the event the scissor lift is overloaded, weight must be removed from the platform to resume operation.

Why is my scissor lift beeping?

When the Auto level module is operating correctly: Once the outriggers pads are in contact with the ground, the green LED lights on the outrigger push-button will light. The TZ will then lift up at the back end until the tires are slightly off the ground, at this point the module will beep.

How do you charge a scissor lift battery?

How to Charge a Scissor Lift: Everything You Need to Know

  1. Park the Scissor Lift. Ensure the scissor lift is parked in a designated work area.
  2. Turn the Lift-Off. Power down the scissor lift.
  3. Connect the Lift to a Battery Charger.
  4. Confirm the Charger Is Working.
  5. Disconnect the Charger.

Where is the serial number located on a Genie scissor lift?

The serial plate is located on the control box side above the swing motor.

Where is the alarm on a scissor lift?

Back-Up Warning Alarms for Aerial Lifts Aerial Equipment Parts offers a huge selection of back-up alarms for aerial lifts, boom lifts or scissor lifts. Each back-up horn sends a clear, distinct warning alarm to notify all in the general vicinity of machinery in reverse.

How do you turn off a scissor lift?

Use the big red button to stop the machine at any time. This is the emergency shut off button, and pressing it will immediately cut the power to the battery. If you need to restart the machine after using the emergency shut off button, simply pull the button out and use the key to restart the scissor lift.

How do I calibrate my genie remote?

Return the joystick to the neutral position, pause for 5 seconds, then move the joystick full stroke in the opposite direction, holding for 5 seconds and then return the joystick to the neutral position. Result: The alarm should sound indicating successful joystick calibration. Select a joystick to calibrate.

How do I know if my Genie scissor lift is charging?

Confirm the Charger Is Working Look at the scissor lift’s battery charger and verify its light is illuminated. Once a lift is fully charged, the light will typically turn green. At this point, the charger will automatically shut off, too.

Where can I find fault codes on my Genie scissor lift?

Please note: Fault Codes showing on ground control can be found starting on page 182 of the Genie Scissor Service and Repair Manual found here or by visiting Genie Service Manuals web page found here. For service for your Genie Scissor Lift please contact your local Genie dealer via the Dealer Locator.

What is the danger in the Genie gs-1530 service manual?

Part No. 39528 Genie GS-1530 & GS-1930 Service Manual – First Edition iii Danger Failure to obey the instructions and safety rules in this manual and the appropriate Genie GS-1530 & Genie GS-1930 Operator’s Manual will result in death or serious injury.

Why is my Genie lift not working?

If you mean code 02. Check the harness coming out of the upper control box. Broke wire is common. Just making sure. This is also a genie lift? Not necessarily. Can you get the lift to raise enough to see the level sensor?

How to check for a broken wire on a Genie lift?

If you mean code 02. Check the harness coming out of the upper control box. Broke wire is common. Just making sure. This is also a genie lift? Not necessarily. Can you get the lift to raise enough to see the level sensor? Make sure something didn’t get jammed under it. See if wire is broke.