How do you use photosensitive dry film on PCB?

The basic stages are;

  1. Prepare transparencies.
  2. Prepare PCB for coating.
  3. Coat PCB with dry film.
  4. Expose coated PCB through transparency using UV light.
  5. Develop exposed PCB.
  6. Wash and Dry developed PCB – preferably overnight, then re-expose to UV to fully harden the dry film.
  7. Etch the PCB.
  8. Clean off etch resist.

What is PCB film?

PCB photosensitive dry film for circuit production. Features: Photographic film, also known as dry film, is used to make PCB board, stick it on top of the PCB, it will become a sensitive circuit board. Suitable for plating, hole covering, and the etching process.

How do you etch a PCB at home?

Dissolve 2-3 teaspoons of ferric chloride power in the water. Dip the PCB into the etching solution (Ferric chloride solution, FeCl3) for approximately 30 mins. The FeCl3 reacts with the unmasked copper and removes the unwanted copper from the PCB. This process is called Etching.

How do you make homemade PCB?

For this tutorial, let’s consider making a PCB for a simple project- a Touch Switch using IC555.

  1. STEP 1: Take a printout of circuit board layout.
  2. STEP 2: Cut the Copper Plate for the Circuit Board.
  3. STEP 3: Transfer the PCB Print onto the Copper Plate.
  4. STEP 4: Iron the Circuit from the Paper onto the PCB Plate.

Which liquid is used for PCB design?

Currently used for print circuit board etching of solvents are iron (Ferric Chloride), cupric chloride (Cupric Chloride), alkaline ammonia (Alkaline Ammonia), sulfuric acid hydrogen peroxide (Sulfuric Acid + Hydrogen Peroxide) etching fluid, ammonium persulfate, sulfuric acid – chromic acid etching solution.

Is Arduino a PCB?

What is Arduino PCB? Arduino is a type of printed circuit board that is an open-source platform. These circuit boards are utilized in developing electronics projects. These boards are based on easy-to-use software and hardware.

What type of film is used to make PCB board?

Photographic film, also known as dry film, is used to make PCB board, stick it on top of the PCB, it will become a sensitive circuit board. Suitable for plating, hole covering，and the etching process.

How to use dry film photo resist for image transfer in PCB?

The photopolymerization characteristic and the convenience of dry film photo resist make it useful for image transfer in PCB fabrication. Ideally, the dry film imaging process should be done in a clean room with amber light illumination. Dust is a killer in fine line construction.

What is the lamination speed of a dry film PCB?

The lamination speed is around 3 to 5 fpm. After the dry film laminated PCB is cooled down, it is ready for imaging. Dry film polymer is sensitive to near UV radiation, around 350nm to 400nm. Hence, the resist and the dry film process is better to be handled in an area with amber or yellow lights to minimize UV radiation.

What is the best way to image transfer on a PCB?

Dry Film Imaging of PCB The photopolymerization characteristic and the convenience of dry film photo resist make it useful for image transfer in PCB fabrication. Ideally, the dry film imaging process should be done in a clean room with amber light illumination. Dust is a killer in fine line construction.

By